Find out more about the commands I mention here by the following link. The important things and step sequence are highlighted in red. Therefore, to make long story short, I’ll describe the configuration only for N201 and certain differences relating to N202 node. So, I have N201 and N202 servers, and both guys are absolutely identical. Check out whether the network works between the VMs.Connect the recently created network to the virtual machines on the hosts.Acquire the necessary information for network creation.Connect to the ESXi hosts with PowerCLI.
HOW TO ADD A VLAN TO VMWARE VSPHERE 6.5 WEB WINDOWS
After that, I’ll check the result using two VMs (VM-01, VM-02), once again, under Windows Server 2016 orchestration, on nodes N201 and N202 correspondingly. To make it convenient, I’ll run the configuration with PowerCLI from the third physical node under Windows Server 2016 (N200) administration over 192.168.1.0/22 network.
Such network is usually used to build fault-tolerant clusters based on VMware solutions. So, what I’m gonna do with that? Well, create a 10 Gbit/s virtual network (10.0.0.0/24). The figure below addresses the configuration scheme of the setup: The server under Windows Server 2016 administration and with VMware.PowerCLI 10.300 deployed is used only for management. The setup usedįor this small experiment I deployed a two-node VMware ESXi 6.5.0 (build 5969303) setup of the following configuration: Yep, it took me some time but at the end of the day, the knowledge and experience I acquired paid back! Apparently, this case is not unique, so I decided to share my experience in today’s scribbling. Sure, I had to dig into the details of orchestrating ESXi with PowerCLI. This command-line tools allows automating all aspects of vSphere management, including network, storage, VM and so on and so forth.
That’s right, I’m talking about PowerCLI. Recently, I decided to automate some boring routine procedures related to setting up virtual networks in ESXi 6.5.
0 kommentar(er)
